The method to transfer OS files varies depending on the OS version of the XTOP product.

 

You can check the OS version on the XTOP device under [Menu Screen] – [Information].

 

If the OS version is V3.1
1. Run the software XDesignerPlus V2.6 and select the [Transfer – Run Transmitter] menu.

 

2.Click the [File Select] button and choose the file named [xtop rom2 v3.1(20**..).bin] from the path:
C:\Program Files (x86)\M2I Corp\XDesignerPlus\OS
(The path may vary depending on your initial software installation.)

 

3.Set the transfer channel (Ethernet/USB/Serial) according to the cable connected to the XTOP device, then click the [Transfer] button to send the OS file.

 

4.After the transfer completes, the device will automatically reset.

 

If the OS version is V4.8
1.Run the software XDesignerPlus V4.8 and select the [Transfer – Run Transmitter] menu.

 

2.On the top left, select [Transfer OS and Font], then click the [File Select] button in the middle right. Choose the OS file starting with OS0000 from the path:
C:\Program Files (x86)\M2I Corp\XDesignerPlus4\OS\OS
(You must change the file type filter to [OS File (*.bin)] to see the OS files. Files starting with OS1000 are for HTOP devices.)

 

3.Set the transfer channel (Ethernet/USB/Serial) at the top right according to the cable connected to the XTOP device, then click the [Transfer] button to send the OS file.

 

Additional Note
For TOPR/RX/RW/RE/RH series, the OS is automatically updated when transferring project (drawing) files, and OS/Font files cannot be transferred separately.